RevPi MIO – Analog & Digital I/O Module
Analog Inputs and Outputs
The 8 analog inputs and 8 analog outputs can be connected via the 28-pin terminal connector on the front of the module. Both the inputs and the outputs operate with 0 – 10 V. Variable switching thresholds allow the analog inputs to behave like digital inputs. The switching thresholds can be set for each channel. Each analog input is high impedance with a 100 kΩ input resistor and has a hardware filter with a cutoff frequency of 1.5 kHz. Additionally, each input is protected against ESD pulses by a protection diode.
The analog outputs can also be configured to output a constant, predefined voltage. This allows the analog outputs to be used like digital outputs and logic levels up to 10 V can be used.
Digital inputs and outputs
In addition to its analog inputs and outputs, the RevPi MIO also features 4 digital channels. Each channel can be configured either as digital input or digital output via the Revolution Pi configuration tool PiCtory. Furthermore, the following operating modes can be set: PWM input, pulse measurements, GPI 24 V, PWM output, pulse output & GPO 24 V level output.