help Wlan0, eth0, eth1 config

[Briooosa]

Hello i need to config Wlan0 and eth0 as static Ip, diferent networks, how can i do it from comand line?

i already did it from startx, but i need to do it from putty, so, i already try to change the

/etc/network/interfaces/ - didn´t work
and if change the /etc/dhcpcd.conf - didn´t work as well.

Another thing where i config the SSID and PASS for the Wlan0 connection?

Thank you, i have 6 revolution connect 4 to do it, so hope you can help .

[dirk]

Hello Briooosa, since RevPi Bullseye OS there is a nice tool that you can use perfectly under PutTTy. Take a look at this entry from our Knowledge Base at How do I configure the network under Bullseye? How is this different from previous versions such as Stretch?

[Briooosa]

Thank you Dirk, it works very well .

Just one more question, if i enable external-antenna, the device just can work on 2.4 Ghz? Or if i use an 5ghz antena and connect to a 5ghz ssid it will work on 5ghz as well?

[dirk]

Hello, the RevPi Connect 4 can be operated in both the 2.4 GHz and 5 GHz frequency bands with the corresponding antennas. Here is the link to the data sheet:
https://revolutionpi.com/en/tutorials/d ... enblaetter