DIO Module not starting

mknopf · Post by **mknopf** » 24 Jun 2024, 10:28

Hello all,

I have updated my installation by changing the code name in the apt source lists from stretch to buster. After that I have done the apt dist-upgrade. Everything works without any problems. I got the RevPi running and it has even the same network settings.
After a day and some reboots the DIO is now not going to reconnect to the main module bus master. According to the LED blink pattern (red blinking) the module can not communicate to the head module (RevPi Connect / 100274). Some days later, it can communicate again, but only one day. Since there, it is still in error mode.

Best regards,
mknopf

Post by **dirk** » 24 Jun 2024, 15:20

Hi mknopf, please try to update your system with the checklist
[edited]
https://kunbus-gmbh.atlassian.net/servi ... /836468748

Please check if there is more recent firmware for the modules:
https://revolutionpi.com/en/tutorials/i ... are-update

Finally, when all else fails you can send me an SOS report:
https://kunbus-gmbh.atlassian.net/servi ... 2036400208

mknopf · Post by **mknopf** » 27 Jun 2024, 07:02

Hi dirk, thanks for the links.
The first link points to the same location as the third one. I guess you wanted to point to:
https://kunbus-gmbh.atlassian.net/servi ... /836468748

At the end, I have reinstalled the revpi-firmware package and afterwards updated the RevPi Connect. The problematic DIO module, I have updated with an other RevPi from version v1.4 to v1.5. Since then, there was no outage yet. I will keep it monitored.

Best regards,
mknopf

Post by **dirk** » 02 Jul 2024, 10:55

Hi mknopf, thank you for your helpful feedback. Yes there has been a typo in the link that you have perfectly seen should go to the Revolution Pi Checklist - I have corrected it.
I am surprised that you had to reinstall the "revpi-firmware" package. Ok, but I'm glad to hear that you were able to solve the problem by updating the firmware to version 1.5.