POlf
Topic Author
Posts: 1
Joined: 22 Nov 2023, 16:04
Answers: 0

Modules cannot be found with CoreS module after updating to Bullseye

22 Nov 2023, 16:19

Hello,

I currently have one DIO and AIO module connected to my Core S module with Bullseye. After setting it up in Pictory like shown below, I still get a
Module is NOT present, data is NOT available!!!
error message when I enter piTest -d in the console
pictory.png
pictory.png (175.61 KiB) Viewed 9353 times
piTest -d.png
piTest -d.png (16.02 KiB) Viewed 9353 times
When setting up the modules in Pictory, I did so by dragging the devices as they are setup physically, then File >> Save as Start-Config, Tools >> Reset Driver

Looking at the LED status on the modules, both DIO and AIO are stuck with the Power Led blinking red constantly. The pi bridges are connected properly and everything is wired properly. I've tried this before with Buster and everything is working without any issues. Everything is physically setup the same as when I was using Buster.

Any help is appreciated. Thanks in advance!
 
User avatar
stefanh
KUNBUS
Posts: 31
Joined: 05 Apr 2023, 10:53
Answers: 0

Re: Modules cannot be found with CoreS module after updating to Bullseye

28 Nov 2023, 07:53

Hello,

We have a similar case that is being discussed here in the forum.

viewtopic.php?t=4138

Regards
Stefan

Who is online

Users browsing this forum: Majestic-12 [Bot] and 2 guests