is there any way to simulate the DIO module inputs and outputs via a graphical interface by using buttons and indicators
i need to test my code on my computer before setting it on RevPi.
thanks for the quick responseAt the moment not as fine as is should be
You can "sudo apt-get install revpipyload" on your Revolutoin Pi and set the XML-RPC service on. At the new version just run "sudo revpipyload_secure_installation" and say YES to "allow from local network" and YES to "setup ACL". Than you can install RevPiPyControl on your network computer and connect to your revpi.
With this Program you can watch die IOs and switch outputs.
To simulate Inputs, you have to stop the piBridge bei "piTest -S". Than run your program with RevPiPyLoad (upload it via RevPiPyControl). If the program is running, you can start python3 on your RevPi and import revpimodio2 and type rpi=revpimodio2.RevPiModIO(autorefresh=True, simulator=True). Now you can set Inputs to values with rpi.io.InputName.value = True, which your control program will see and to the work
You will have the logs in RevPiPycontrol and a "PLC Developer" Mode to easily upload your python files, check it out in the "PLC" menu.
The next version will have an simulator mode, to set Inputs with the GUI
self.revpi = revpimodio2.RevPiModIO(autorefresh=True, direct_output=True, configrsc=root + "\opt\KUNBUS\_config.rsc", procimg=root + "\dev\piControl0")