I have found that is I stop the codesyscontrol then I am able to correctly operate everything via the Pictory configuration. I think the issue is codesys isn't allowed permission to write configurations to the modules, or is trying to configure them to the wrong addresses. How would I make sure ...

I have a RevPi DIO module connected to a RevPi Connect 5 and am trying to read the input pins. I have 24V connected to the DIO power and Input and Output powers. I then have a cable connected to a device that when there's an error will go from 24V to 0V. Therefore I want to be able to read whether ...

Hi RamiGspo,

The polarity of the wires is correct and I have bridged between the two and used the same wires that power the Input side, where if I disconnect those wires the Input LED turns Red as well so I know those cables work, but when they are connected to the Output power terminals the Output ...

Hi Amar,

Thank you for getting back so quickly, sorry I've taken so long to check this.

Step 1:
The piTest -x doesn't change the status of the Out LED on the DIO module.

Step 2:
Stopping codesys and then running piTest -x has the same result as step 1.

Step 3:
Creating a fresh config with only ...

I am trying to create a circuit with a RevPi Connect 5 and a MIO and DIO modules. The MIO module works perfectly fine, but the DIO module's Output LED remains red no matter what I do. I have connected 24V PSU supply to the Input and Output pins on the top of the DIO module, and have a 24V supply to ...

Hi my RevPi DIO output light won't turn green, it stays red. I have made sure there is sufficient 24V power to the top and bottom and the RevPi Connect 5 I am using sees the DIO module, but the Output LED remains red and I can't get the DIO outputs to work.

Hi I am also having the same issue with my DIO module connected to a MIO module and RevPi Connect 5. I have connected the cables on top to the same 24V PSU and a separate 24V PSU but the Output LED on the DIO module stays red and won't turn green, even though the Input LED turns green. I am using ...