Hi crismancich,
I solved the problem by using your suggestion in a ladder structure, precisely the one shown in the picture below:
Schermata 2021-12-18 alle 18.25.57.png
The input of this submodule is activated at start-up: the shown subflow then takes a screenshot of the input status and send it ...

HI crismancich,
Thank you for the flow you suggested: do this implies that it is not possible to "take a picture" of all inputs jointly, for example by using some initial state of the node revpi-multiple-input ? I mean, if I need to know the state of all inputs at a given time, possibly in the form ...

The title says all: I'd like to know if a message is generated at turn on to make a Node-Red system aware of the status of DIO inputs. I see that when an input changes, the associated payload property assumes a string value "1": however the other properties have an integer 0 or 1 value, thus I'd ...

I had the same problem last week with my laboratory Core 3+: then I flashed the Buster image and it now works correctly.

Hi Amar,
I just tried your solution: it works perfectly, as my workaround does. Thank you very much.


Hi Daniele,
Could you please repost the screenshots attached in your post since they are not visible. I would recommend you to carry out following steps so that I can reproduce the issue:

1 ...

Hi Johannes,


I had a conversation with our hardware team.
You should not expect any damage in your described case.

Resetting after few seconds? Maybe 60 seconds? Maybe you mean the Watchdog?
Watchdog


After your Iatest message, I checked and I found that you're right: the connector change ...

Hi Daniele,


Hi Johannes, and first of all thanks for your help.


for better understanding:

X4:1 connected to 24 V
X4:2 unconnected
X4:3 connected to Ground
X4:4 connected to FE

Right?


No, the sequence was

X4:1 connected to 24 V
X4:2 connected to Ground
X4:3 connected to Ground
X4:4 ...

@Julian, first of all I apologize for the later in my answer. Perhaps you have to configure again the inputs by using Pictory: I did it so and I have not seen the issue you are experimenting.

I am well aware that, as advised by this manual web page , pin 3 of the X4 connector of the DIO should be left unconnected: however our electrician has employed a new person who does not know well the electrical schematics of the electrical cabinet where we mount a RevPi Connect+DIO pack, so they ...

Hi Amar,
First of all, thank you for the reply and please accept my apologies for my later one.

Could you please repost the screenshots attached in your post since they are not visible. I would recommend you to carry out following steps so that I can reproduce the issue:

For the images: I am ...