The Industrial Raspberry Pi Forum

Hello everyone,Im newbie using RevPi, I have a project using Revpi Connect +, I followed the steps when starting to work as instructed, but when it comes to scanning the device and configuring the gatewayby ethernet i use software CODESYS , I can't do it. I hope you can help me, thank you.

Hi kemkik849, take a look at the CODESYS Checklist. There is also a nice little video that shows the steps to commission CODESYS with a Revolution Pi Module.

I made sure to follow the video instructions step by step but it still doesn't work and I can't find my device.

Do you have a valid license or is it in demo mode? Then the CODESYS runtime will stop after about 1 hour. Maybe you have to restart the device and try it again if in demo mode.