Modules cannot be found with CoreS module after updating to Bullseye
Posted: 22 Nov 2023, 16:19
Hello,
I currently have one DIO and AIO module connected to my Core S module with Bullseye. After setting it up in Pictory like shown below, I still get a
When setting up the modules in Pictory, I did so by dragging the devices as they are setup physically, then File >> Save as Start-Config, Tools >> Reset Driver
Looking at the LED status on the modules, both DIO and AIO are stuck with the Power Led blinking red constantly. The pi bridges are connected properly and everything is wired properly. I've tried this before with Buster and everything is working without any issues. Everything is physically setup the same as when I was using Buster.
Any help is appreciated. Thanks in advance!
I currently have one DIO and AIO module connected to my Core S module with Bullseye. After setting it up in Pictory like shown below, I still get a
error message when I enter piTest -d in the consoleModule is NOT present, data is NOT available!!!
- pictory.png (175.61 KiB) Viewed 12037 times
- piTest -d.png (16.02 KiB) Viewed 12037 times
Looking at the LED status on the modules, both DIO and AIO are stuck with the Power Led blinking red constantly. The pi bridges are connected properly and everything is wired properly. I've tried this before with Buster and everything is working without any issues. Everything is physically setup the same as when I was using Buster.
Any help is appreciated. Thanks in advance!