Page 1 of 1

Bad RevPi Coonnect?

Posted: 27 May 2021, 14:55
by christianascott1111
I plugged into 24 volts and am not getting any lights for ethernet when I plug in a cable. I have checked cables with pc and the 3 cables I tested work. I am not able to connect with RPIboot I am getting failed to write correct length, returned 0. I have plugged and replugged in the usb. PWR WD and REL are on. Pi doesn't show on network.

Re: Bad RevPi Coonnect?

Posted: 01 Jun 2021, 11:14
by dirk
Hi christianascott1111, obviously it is a defective unit here. The last possible idea is that you work through the checklist to avoid an unnecessary MA case. This is located here in our support knowledge base:
https://kunbus-gmbh.atlassian.net/servi ... /836468748

The login page is unfortunately only available in German at the moment and you need to register with an email address to access the article. Here is a short animation how it works:
Video.JSD.Registration GIF.gif
Video.JSD.Registration GIF.gif (755.56 KiB) Viewed 1992 times