System RS485 application initialization failed

Topics about the Software of Revolution Pi
Post Reply
Purecade
Posts: 63
Joined: 07 Sep 2021, 03:39
Answers: 0

System RS485 application initialization failed

Post by Purecade »

Hello,

In the process of applying RevPi Connect module, I encountered a very strange problem: RevPi Connect module is connected to an RS485 device, and a MODBUS RTU master is configured on PiCtory to read and control the RS485 device. Theoretically, when the RevPi Connect module is powered on, it will automatically establish communication with the RS485 device. But in practice, when I apply it, it fails to communicate with the RS485 device, and I need to manually Reset Driver on PiCtory to communicate successfully.
To verify the problem, I re-wrote the new system for the RevPi Connect module, but unfortunately, the problem still exists. I have another RevPi Connect module for which I wrote the same system, and it also has the problem. After I finished the Pictory configuration, I re-powered off and on and checked the pictory and found that my configuration was not saved.
I think this is a bug in the software system,do you have any solution?

Best regards,
Purecade
giuseppe
KUNBUS
Posts: 91
Joined: 09 Mar 2022, 13:08
Answers: 0

Re: System RS485 application initialization failed

Post by giuseppe »

Hello Purecade,

which image version did you use?

Go through the checklists. This may solve the problem.
Revolution Pi Checklist
Modbus Checklist

Best regards
Giuseppe Pagano
Post Reply